Efficient Power Conversion (EPC) Widens the Performance Gap with the Aging Power MOSFET with “Off-the-Shelf” High Performance Gallium Nitride Power Transistors
eGaN® power transistors continue to raise the bar for power conversion performance. Lower on-resistance, lower capacitance, higher current, and superior thermal performance enable power converters with greater than 98% efficiency.
To tweet this news, copy and paste http://bit.ly/EPCXLPR1407 to your Twitter handle with #GaNFET
EL SEGUNDO, Calif.--(BUSINESS WIRE)--Efficient Power Conversion Corporation (EPC) announces the introduction of six new-generation power transistor products and corresponding development boards. Ranging from 30 V to 200 V, these products provide significant reduction in RDS(on) greatly increasing their output current capability in applications such as high power density DC-DC converters, Point-of-Load (POL) converters, synchronous rectification in DC/DC and AC/DC converters, motor drives, LED lighting, and industrial automation.
New eGaN FET Products with Supporting Development Boards
(VGS = 5 V)
Max. Peak Pulsed
Tpulse = 300 µs)
- Lower On-resistance (RDS(on))
The new family of eGaN FETs cuts on-resistance (RDS(on)) in half, enabling high current, high power density applications.
- Improved Figure of Merit (FOM)
The latest generation of eGaN FETs cuts the hard-switching FOM in half compared with the previous generation for improved switching performance in high frequency power conversion applications.
- Extended Voltage Range
Extending the performance benefits of GaN to 30 V enables higher power DC-DC converters, Point-of-Load (POL) converters, synchronous rectifiers for isolated power supplies, PCs, and servers.
- Better Thermal Performance
Increased temperature capabilities and improved die layout improve the thermal and electrical performance of the Gen 4 family of devices allowing for higher power operation under all conditions.
Demonstrated Power Conversion Efficiency Improvements
To demonstrate the improved performance of these new eGaN FETs, two buck converters were built. The EPC9018 combines the 30 V EPC2023 FET as the synchronous rectifier with the 40 V EPC2015 as the control switch of a 12 V – 1.2 V DC-DC point of load (POL) converter.
The 12 V to 1.2 V, 40 A POL converter operating at switching frequency of 1 MHz achieved efficiencies above 91.5% and demonstrated the superior in-circuit performance of the latest generation of eGaN power devices compared to the state-of-the-art Si MOSFET modules.
The EPC9019, a 48 V – 12 V converter, uses the 80 V, EPC2021 as the synchronous rectifier switch with the 100 V EPC2001 as the control switch. The results of this 48 V to 12 V, 30 A non-isolated DC-DC intermediate bus converter operating at a switching frequency of 300 kHz achieved efficiencies above 98%, again significantly outperforming a comparable converter using state-of-the-art silicon power MOSFETs.
Detailed results of these in-circuit demonstrations of eGaN FETs can be seen at http://bit.ly/EPCAN017.
To simplify the evaluation process of the latest high performance eGaN FETs, development boards are available to support easy “in circuit” performance evaluation of each new product being introduced (reference table given above). These boards include all the critical components on a single board that can be easily connected into any existing converter.
The EPC9014 and EPC9031 through EPC9034 development boards are half-bridge configurations with onboard gate drives, featuring various eGaN power transistors. All boards are 2” x 1.5” and contain two eGaN FETs using the Texas Instruments LM5113 gate driver, supply and bypass capacitors. Each board contains all critical components and layout for optimal switching performance.
The EPC9018 and EPC9019 development boards mentioned above are also available for easy “in circuit” performance evaluation.
Price and Availability
Pricing for the EPC2019 – 24 power transistors at 1K units starts at $3.14 each and are available for immediate delivery from Digi-Key at http://digikey.com/Suppliers/us/Efficient-Power-Conversion.page?lang=en
Pricing for corresponding development boards start at $104.40 each and are available for immediate delivery from Digi-Key at http://digikey.com/Suppliers/us/Efficient-Power-Conversion.page?lang=en
Design Information and Support for eGaN FETs:
- Download EPC eGaN FET datasheets at http://epc-co.com/epc/Products.aspx
- Download development board Quick Start Guides: http://epc-co.com/epc/Products/DemoBoards.aspx
- Application Note: Fourth Generation eGaN FETs Widen the Performance Gap with the Aging MOSFET at http://bit.ly/EPCAN017
- Watch short video presentation of Fourth Generation products: http://epc-co.com/epc/DesignSupport/TrainingVideos/Generation4eGaNFETs.aspx
EPC is the leader in enhancement mode gallium nitride based power management devices. EPC was the first to introduce enhancement-mode gallium-nitride-on-silicon (eGaN) FETs as power MOSFET replacements in applications such as DC-DC converters, wireless power transfer, envelope tracking, RF transmission, solar micro inverters, remote sensing technology (LiDAR), and class-D audio amplifiers with device performance many times greater than the best silicon power MOSFETs.
Visit our web site: www.epc-co.com
Sign-up to receive EPC updates via email: http://bit.ly/EPCupdates or text "EPC" to 22828
Follow EPC on Twitter at http://twitter.com/#!/EPC_CORP
Like EPC on Facebook at http://www.facebook.com/EPC.Corporation
eGaN is a registered trademark of Efficient Power Conversion Corporation, Inc.